HT-CT800
Ver. 1.3
2-17. WLAN/BT COMBO CARD (WIFI1)
Note 1: When the WLAN/BT combo card (Ref. No. WIFI1) is re-
placed, refer to "NOTE OF REPLACING THE MB-1612
BOARD OR WLAN/BT COMBO CARD" on page 5.
top side
[white]: No. 2
[gray]: No. 3
front
side
Pass the coaxial harness
across the front side of
the screw hole.
7 WLAN/BT combo card (WIFI1)
Note 4: When installing the WLAN/BT combo card,
align the rib and groove.
22
1 cushion (WIFI label)
2 connector (No. 3)
2 connector (No. 2)
front side
6 CNC label (AR2)
3 screw
groove
4 claw
radiation sheet
rib
Note 2: If the radiation sheet is damaged, be sure to replace them with
new parts.
Note 3: This part is deleted from
guide line
[gray]
guide line
[white]
front side
Pressing the adhesive area.
2 connector (No. 1)
[black]
rear side
[black]: No. 1
Pass the coaxial harness
(BVTP3
8)
across the rear side of
the screw hole.
5 MB-1612 board
cable connector
the midway of production.
cushion (WIFI label)
bottom cabinet block
front side
SYS SET