Electrical Connection; Connection And Safety Information; 3-Wire System (Output Code Pnav); Commissioning - GEM 3240 Operating Instructions Manual

11 Electrical connection

Connect the product in accordance with the pin assignment.

11.1 Connection and safety information

Devices with cable glands and cable sockets
1. Ensure that the outside diameter of the cable used is
within the permissible clamping range (cable gland M12 x
1.5 cable dia. 3–6.5 mm, cable socket ISO 4400 cable dia.
4.5–10 mm). In addition, make sure that the cable is
seated securely in the cable gland, without any gaps.
2. Use a shielded, twisted multicore cable for the electrical
connection.
Devices with a cable outlet
Comply with the following minimum bend radii when laying
the cable:
– Cable without air hose:
Fixed in place: 5 x cable diameter
Flexible use: 10 x cable diameter
– Cable with air hose:
Fixed in place: 10 x cable diameter
Flexible use: 20 x cable diameter
On devices with a cable outlet and integrated vent tube, the
PTFE filter on the cable end on the gauge tube must not be
damaged or removed.
▶ Cables used for gauge devices have a vent tube for
equalizing the pressure. Route the cable end into an area
or suitable terminal box that is as free from moisture and
corrosive gases as possible in order to prevent damage.

11.2 3-wire system (output code PNAV)

2
1
3
4
Pin
1 Supply +
2 Switching output / Signal
3 Supply -
4 Switching output / Communication
P
Supply +
Supply -
Switching output/signal
Switching output/
I/U
communication
www.gemu-group.com
NOTICE
Description
R
L
A/V
IO-Link master

12 Commissioning

1. The device must be properly installed
2. The device must not exhibit any visible defects

13 Operation

13.1 Operating and display elements

1
7
Fig. 1: Operating screen for device with two switching out-
puts
1 = Three LEDs for displaying units
2 = LED IO-Link red: Status indication IO-Link
3 = LED Out 1 yellow: Switching output 1 status indication
4 = LED Out 2 green: Switching output 2 status indication
5 = Seven-segment display for measured value and paramet-
ers
6 = Key for moving within a menu
7 = Key for moving from menu to menu
Red LED
Yellow LED On
Green LED
Press briefly
Press and
hold
U
B
Press briefly
Press and
R
hold
L
Press both
keys at the
same time
The device is configured in accordance with VDMA 24574-1.
13 / 28
3 4
2
5
6
LED status in normal mode
On IO-Link active (master slave
operation)
Off IO-Link inactive (no master slave
operation)
Switch point 1 reached, switching
output active
Off Switch point not reached
On Switch point 2 reached, switching
output active
Off Switch point not reached
Tastenfunktion
Scroll from menu 1 to menu 5, then
return to the display
Increase parameter values quickly
Select a menu item in a menu
Apply the set parameter and return to
the current menu item
Return to the display
13 Operation
GEMÜ 3240