Table of Contents
Advertisement
1 General information
1 General information
1.1 Information
–
The descriptions and instructions apply to the stand-
ard versions. For special versions not described in this
document the basic information contained herein ap-
plies in combination with any additional special docu-
mentation.
–
Correct installation, operation, maintenance and repair
work ensure faultless operation of the product.
–
Should there be any doubts or misunderstandings, the
German version is the authoritative document.
–
Contact us at the address on the last page for staff
training information.
1.2 Symbols used
The following symbols are used in this document:
Symbol
Tasks to be performed
Response(s) to tasks
–
Lists
1.3 Warning notes
Wherever possible, warning notes are organised according to
the following scheme:
SIGNAL WORD
Type and source of the danger
Possible
symbol for
Possible consequences of non-observance.
the specific
danger
Measures for avoiding danger.
Warning notes are always marked with a signal word and
sometimes also with a symbol for the specific danger.
The following signal words and danger levels are used:
Imminent danger!
▶ Non-observance can cause death or
severe injury.
Potentially dangerous situation!
▶ Non-observance can cause death or
severe injury.
Potentially dangerous situation!
▶ Non-observance can cause moderate
to light injury.
GEMÜ 3240
Meaning
DANGER
WARNING
CAUTION
Potentially dangerous situation!
▶ Non-observance can cause damage to
The following symbols for the specific dangers can be used
within a warning note:
Symbol
Danger – high voltage
2 Safety information
The safety information in this document refers only to an in-
dividual product. Potentially dangerous conditions can arise
in combination with other plant components, which need to
be considered on the basis of a risk analysis. The operator is
responsible for the production of the risk analysis and for
compliance with the resulting precautionary measures and
regional safety regulations.
The document contains fundamental safety information that
must be observed during commissioning, operation and
maintenance. Non-compliance with these instructions may
cause:
–
Personal hazard due to electrical, mechanical and
chemical effects.
–
Hazard to nearby equipment.
–
Failure of important functions.
–
Hazard to the environment due to the leakage of dan-
gerous materials.
The safety information does not take into account:
–
Unexpected incidents and events, which may occur
during installation, operation and maintenance.
–
Local safety regulations which must be adhered to by
the operator and by any additional installation person-
nel.
Prior to commissioning:
1. Transport and store the product correctly.
2. Do not paint the bolts and plastic parts of the product.
3. Carry out installation and commissioning using trained
personnel.
4. Provide adequate training for installation and operating
personnel.
5. Ensure that the contents of the document have been fully
understood by the responsible personnel.
6. Define the areas of responsibility.
7. Observe the safety data sheets.
8. Observe the safety regulations for the media used.
4 / 28
NOTICE
property.
Meaning
www.gemu-group.com
Advertisement
Table of Contents
