Interflex IF-800 VP Manual

95-10294 V2016-10-20 IF-800 VP
IF-800 VP
1 IF-800-VP
Thank you for using a terminal of the series IF-800 VP for recording access
data
(VP= vandal-proof, degree of protection in accordance with DIN EN 50102
IK08).
Scope of delivery:

Housing ring with IF-800 VP slave terminal with 5 m connecting cable

Screw cover with Makrolon insert

I/O controller board for controlling locking devices

Terminal strip board

Material for fastening
Please check the completeness and condition of the shipment upon
receipt.
2 Usage in Accordance with the Intended Purpose
IF-800 VP terminals are devices for controlling the access of persons as well as for controlling and
monitoring locking devices. Any other use is not in accordance with the intended purpose and is therefore
not permitted.
The internal hardware of the IF-800 VP is identical to that of the IF-800 slave terminal. For more information
on connections and required settings, please refer to the IF-800 documentation no. 95-10287.
3 Function of the IF-800-VP Slave Terminal
In general, IF-800 VP slave terminals are connected to a master terminal, an access manager or a terminal
controller via an RS485 data cable. Terminals of the series IF-800 VP are designed for controlling the access
of persons, who identify themselves with RFID credentials, as well as for controlling and monitoring locking
devices.
We recommend:

installing a separate, fuse-protected circuit.

keeping a minimum distance of 30 cm between the slave terminal and other systems with RFID readers.

keeping a distance of 10 cm between connecting cables and power lines.
Interflex Datensysteme GmbH 1/7