Installation Of The Wine Cabinet - BORETTI BPWKN 60 Instructions Manual

Installation of the wine cabinet

Note
Before connecting the wine cabinet to the power source, let
it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from
handling during transportation.
* Remove the exterior and interior packing.
* Clean the interior surface with lukewarm water using a soft cloth.
* Install the handle on the left side of the door.
* Place the wine cabinet on a floor that is strong enough to support
it when it is fully loaded. To level the wine cabinet, adjust the front
levelling foot at the bottom of the wine cabinet.
* Locate the wine cabinet away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to
perform properly.
* Avoid locating the unit in moist areas.
* The wine cabinet should be positioned where the ambient
temperature is between 5°C and 35°C. If the ambient temperature
is above or below this range, the performance of the unit may be
affected. Placing the appliance in extreme cold or hot conditions may
cause the interior temperatures to fluctuate. The range of setting
temperatures may not be reached.
* Put the plug of the wine cabinet into an appropriate socket. Should
the plug require changing, get help from a qualified service technician.
38