Table of Contents
Advertisement
8.
Connect the other end of the IDE ribbon cable to the secondary IDE
connector (labeled SEC_IDE) on the motherboard. See page 4-6 for
the location of this connector.
9.
Connect the other end of the audio cable to the black 4-pin connector
labeled CD on the motherboard. See page 4-9 for the location of this
connector.
10. Remove the dummy drive slot cover from the front panel.
10. Replace the front panel. Refer to section "2.11 Replacing the side
plates and front cover" on page 2-20 for details.
A S U S V i n t a g e - A H 1
A S U S V i n t a g e - A H 1
A S U S V i n t a g e - A H 1
A S U S V i n t a g e - A H 1
A S U S V i n t a g e - A H 1
4
3
4
2 - 1 5
2 - 1 5
2 - 1 5
2 - 1 5
2 - 1 5
Advertisement
Table of Contents
