Equalizer Systems El Pac 1 Operation, Troubleshooting & Warranty Manual page 5

5. Drill a hole through the jack shaft using the output shaft of the El
Pac 1 as a guide. Use the supplied 5/16" x 2" bolt and nylock nut
to secure the output shaft to the jack shaft.
6. Mount the switchgear in desired location.
7. Refer to the Power Supply and Switchgear installation
instructions.
Installation of El Pac 1 on Fulton
Installation of the El Pac 1 on a Fulton jack is done the same way as the
Bulldog and Ram jacks with one exception. The Fulton jack has a
smaller shaft than the Bulldog and Ram jacks. To take care of this, you
use the supplied nylon bushing (part # 1961E) around the shaft prior to
sliding the El Pac 1 in place.
Dual Leg Application-The El Pac 1 must be installed on the passenger
side of the passenger side jack leg in a dual leg application. When
properly mounted, this unit has a maximum lifting capacity of 5000 lbs.
of combined jack weight. Due to the additional linkage required to add a
second jack, and the possible misalignment of the jacks, you could
experience a loss of lifting capacity in the 10% range.
3