Equalizer Systems El Pac 1 Operation, Troubleshooting & Warranty Manual page 10

Installation on Driver's Side of Jack Leg (newer style Binkley)
For the most part installation of the El Pac 2 on the newer style Binkley
jack is the same with the following exceptions.
1. Since there is no collar around the input shaft of the newer
Binkley 2-speed jack, after you pull the input shaft out into low
gear, you must measure 2" away from the gear case and cut the
shaft off.
2. On the newer Binkley 2-speed jack, the El Pac 2 mounting
bracket must be welded to the gear case since there is no collar
to bolt to. After the bracket is bolted to the El Pac 2 slide it over
the input shaft, make sure that everything is perfectly aligned
and then weld the bracket to the gear case.
Newer Binkley Two-Speed Jacks-Driver's side installation
Dual Leg Application-The El Pac 2 can be used in a dual leg
application. When properly mounted, this unit has a maximum lifting
capacity of 6500 lbs. of combined jack weight. Due to the additional
linkage required to add a second jack, and the possible misalignment of
the jacks, you could experience a loss of lifting capacity in the 10%
range.
8