Primary And Secondary Master/Slave - Asus Terminator C3 User Manual

Barebone system
Table of Contents

Advertisement

5.3.5
5.3.5
5.3.5
5.3.5
5.3.5

Primary and Secondary Master/Slave

Primary and Secondary Master/Slave
Primary and Secondary Master/Slave
Primary and Secondary Master/Slave
Primary and Secondary Master/Slave
Primary IDE Master
Primary IDE Master
Access Mode
Capacity
Cylinder
Head
Sector
PIO Mode
UDMA Mode
Transfer Mode
Primary IDE Master [Auto]
Primary IDE Master [Auto]
Primary IDE Master [Auto]
Primary IDE Master [Auto]
Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this may
be because the hard disk drive is too old or too new. If the hard disk was
already formatted on an older system, Setup may detect incorrect
parameters. In these cases, select [Manual] to manually enter the IDE hard
disk drive parameters. Refer to the next section for details.
Configuration options: [None] [Auto] [Manual]
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
This item allows the user to select the sector addressing mode.
Configuration options: [CHS] [LBA] [Large] [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
This option lets you set a PIO (Programmed Input/Output) mode for the
IDE device. Modes 0 through 4 provide successive increase in performance.
Configuration options: [Auto] [Mode 0] [Mode 1] [Mode 2] [Mode 3]
[Mode 4]
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
[Auto]
[Auto]
13579 MB
26310
16
63
[Auto]
[Auto]
UDMA 4
Select Menu
Item Specific Help
Press [Enter] to
select.
5 - 1 1
5 - 1 1
5 - 1 1
5 - 1 1
5 - 1 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Terminator 1 c3Terminator 1C3

Table of Contents