Table of Contents
Advertisement
2.7
Installing an optical drive
An optical drive is an optional item in this barebone system. Refer to the
instructions in this section if you acquired a model without an optical drive.
Follow these steps to install a
CD-ROM drive.
1.
Place the chassis upright.
2.
Insert the optical drive into the
upper 5.25-inch drive bay.
3.
Carefully push the CD-ROM
drive into the bay until its
screw holes align with the
holes on the bay as shown.
4.
Secure the CD-ROM with two
screws as shown.
5.
Repeat steps 3 and 4 to install
a second optical drive into the
lower 5.25-inch drive bay.
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
A S U S T e r m i n a t o r 1 C 3 b a r e b o n e s y s t e m
5.25-inch drive bay
C D - R O M s c r e w s
C D - R O M s c r e w s
C D - R O M s c r e w s
C D - R O M s c r e w s
C D - R O M s c r e w s
2 - 1 1
2 - 1 1
2 - 1 1
2 - 1 1
2 - 1 1
Advertisement
Table of Contents
