Spinner A77137 Installation Manual

Installation guide for
In-Building omni antennas

1 Introduction and safety advice

This instruction shall provide information how to install the antenna with mounting kits.
The installation of Thin Omni Chip antennas is not recommended for metal ceilings or nearby
any metallic materials. Additional Isolation/Absorbing accessories can be applied for improving
the Antenna VSWR value.
All shown tasks are intended to be carried out by qualified personnel only. Safety rules apply
(e.g. for working with heavy loads, radio frequency power signals or tools). In order to prevent
damage to equipment and humans, make sure that no RF power is present at the combiner
during installation.
Please note that satisfactory performance of the system (especially in terms of inter-
modulation) can only be achieved if all jumper cables and connectors are handled properly.
Please make sure that all connectors are clean and free from metal dust or dirt. Avoid sharp
bends of the connecting jumper cables.
SPINNER does not guarantee for any faults or damage resulting from improper installation.
Data subject to change without notice – Sep.28.2020 (C)
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ info@spinner-group.com