External Control; Regulatory And Safety Statements - Tesla 24MT600BF User Manual

External control

Number Icon
1
2
3
4
5 q

Regulatory and safety statements

FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is installed in a residential area. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with instructions, may cause
interference to radio communications.
However, there is no guarantee that interference will not occur in a specific installation. If the device does
cause interference to radio or television reception (which can be determined by the switchgear), it is
recommended that the user take one or more of the following measures to eliminate the interference:
• Readjust the direction or position of the receiver antenna.
• Increase the distance between the device and the receiver.
• Connect the device power to a power outlet that is different from the circuit to which the receiver is
connected.
• Contact your retailer or an experienced radio/TV technician for help.
Note
To prevent damage to the monitor, do not lift the monitor using the stand.
Note: Shielded cable
All connections to other computing devices must be through shielded cables to comply with EMC
regulations.
Note: Peripherals
Only certified peripherals (input/output devices, terminals, printers, etc.) that meet Class B limits should
be connected to the device. Using uncertified peripherals may cause interference to radio and television
reception.
Note
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate this product.
Operating conditions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (I)
this device may not cause harmful interference, and (2) this device must be able to accept any interference
received, including interference that may cause undesired operation.
Description
Go to the main menu.
Enter the source mode.
Enter contrast adjustment.
Enter brightness adjustment.
In the powered-off state, pr essing the button powers on the device; in the
powered-on state, pressing the button normally enters the mode switching
menu, and long-pressing for 3 seconds powers off the device.
3
ENG