Fitting Fixed Kick-Plate; Nb! Not All Models - Asko D3530 Use And Care Manual

To prevent kinks, pull the drain hose and the
connecting pipe.
Adjusting the plinth
have kick-plate as accessory)
The dishwasher has two kick-plates (some
models).
The upper kick-plate should be used if the ma-
chine is to be 850 - 870 mm tall and the depth of
the plinth can be varied between 45 - 105 mm. The
lower one is used if the dishwasher is to be 820 -
845 mm tall with a plinth depth of between 50 -
105 mm. Attach the enclosed felt insulation to the
kick-plate (some models).
Set the correct plinth depth as follows:
1. Slide the grey catches towards each other and
pull out the holders as far as required. Slide in the
catches so that they lock the holders in place.
2. Hang the kick-plate onto the holders by insert-
ing it into the grooves.
Screw the dishwasher into place
The enclosed plastic plugs are used for covering
the screw holes if the dishwasher is to be
screwed at the sides. After fixing check that the
front feet are in contact with the floor.
34

Fitting fixed kick-plate

(Only if you
Fitting strip seal
(to the floorplinth's covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth (A), and
break outwards and upwards.
2. Undo the two screws on the covering plate
(B).
3. Glue the accompanying rubber strip (C) to
the underside of the covering plate (against
the floor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber
strip is just in contact with the floor.
5. Replace the plastic plinth
Not all models
x x
B
A
x
C