Screw The Dishwasher Into Place; Fitting Fixed Kick-Plate; Fitting Strip Seal - Asko D3350 Use And Care Manual

To prevent kinks, pull the drain hose and the
connecting pipe.
Adjusting the plinth
(Only with kick-plate as accessory)
The dishwasher has two kick-plates (some
models).
The taller one should be used if the machine is to
be 850 - 870 mm high and the plinth depth can be
varied between 45 - 105 mm. The lower one is to
be used if the machine will be 820 - 845 mm with a
plinth depth of between 50 - 105 mm.
Attach the enclosed felt insulation to the kick-plate
(some models).
Set the correct plinth depth as follows:
1. Slide the grey catches towards each other and
pull out the holders as far as required. Slide in the
catches so that they lock the brackets in place.
2. Hang the kick-plate onto the holders by insert-
ing it into the grooves.

Screw the dishwasher into place

If the machine is to be screwed in at the sides, the
enclosed plastic plugs are used for covering the
screw holes. After fixing check that the front feet
are in contact with the floor.

Fitting fixed kick-plate

Fitting strip seal

(to the floorplinth's covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping
with both hands under the plastic plinth
(A), and break outwards and upwards.
2. Undo the two screws on the covering
plate (B).
3. Glue the accompanying rubber strip (C)
to the underside of the covering plate
(against the floor).
4. Screw the covering plate back into
place. Adjust the covering plate so that the
rubber strip is just in contact with the floor.
x x
5. Replace the plastic plinth
Not all models
B
A
x
C
35