Snorkel A38E Parts And Service Manual page 18

Section
2.7
5. Visually inspect the battery charge indicator
(refer to Figure 2.3).
• The charger will turn on three to five seconds
after a complete electrical connection is made.
• The LED charge indicators will be lit while the
batteries are charging.
• When the batteries are fully charged, the charge
indicator will blink.
A CAUTION A
The batteries may be overcharged and/or
damaged if the charger is plugged in after the
charge cycle is complete. Do not leave the
battery charger on for more than 48 hours.
7. After the charge cycle is complete, unplug the
extension cord from the battery charger and
allow the batteries to cool.
8. Remove the cover on each side of the chassis
to access the batteries. Remove the caps from
each battery.
Note
Machines can also be supplied with maintenance
free batteries, fluid check will not be necessary on
this type of battery.
9. Visually check the battery fluid level making
sure the level is 3/8" (10 mm) above the plates.
If needed, add distilled water.
10. Tightly replace the caps on each battery
Page 10
Machine Preparation
A38E Work Platform