Kasco T8 Use Instructions page 6

INSTRUCCIONES PARA EL USO - Οδηγίες Χρήσης-Instruções

Do not short the terminals.

Do not place battery on or near equipment which vibrates excessively.

In case of battery leakage wash all parts which have come into contact with leaked
liquid immediately.

Do not expose battery to infrared or ultraviolet rays excessively.

Do not pierce, crush, disassemble or open the battery as leaked liquid could catch
fire, explode or release dangerous substances.

Keep the battery charger connected to the battery only if the charger is powered.

The battery charges correctly if charging is carried out at a temperature between
0°C and 40°C. For charging at any other temperature, please contact Kasco.
7.4 Do not use expired filters even if their seals are still intact.

Do not use filters for more than three months.
7.5 Return to fresh, clean air immediately and take OFF helmet if:
a) Leakage is detected by smell, taste or eye, nose or throat irritation.
b) Inhaled air becomes extremely hot.
c) Any feeling of nausea, dizziness or ill being develops.
7.6 THE RESPIRATOR WILL NOT FURNISH BREATHING PROTECTION UNLESS
BLOWER UNITS WHICH DRAW IN AIR THROUGH THE FILTER/S ARE
FUNCTIONING. OXYGEN WILL BE ABSORBED RAPIDLY AND THE CARBON
DIOXYDE CONCENTRATION PRODUCED WITH BREATHING WOULD EXCEED
THE TLV LIMITS.
7.7 Never alter or modify this respirator in any way.
7.8 This equipment is to be used only by qualified personnel who has been trained on
The use and maintenance of Respiratory Protective Devices and who is aware of
their technical and legal limits.
7.9 Do not use the respirator if your sense of smell is in any way impaired.
7.10 Do not use the respirator if it has not been serviced annually by a Kasco authorized
service centre.
8. REPAIRS
8.1. Use only genuine KASCO spares.
8.2. Should you require technical assistance please fill out the form on our website and
possibly include the following information : Respirator type – Serial number – Retailer name
– Problem experienced – Hazard type and concentration – Type of filter used – Frequency
of usage– A job description if useful to identifying the problem.
9. MARKINGS
The CE mark certifies compliance with the essential health and safety
requirements in Annex II of Regulation (EU) 2016/425. The number 0426
after EC identifies the Notified Body ITALCERT control institute of the
finished product in accordance with Regulation (EU) 2016/425.
EXPIRY –year – month
HUMIDITY – maximum
admissible in storage area.
INSTRUCTIONS to be
read before use
a) Example of Air System label:
The label is affixed on the carton containing the Air System.
The PPE, subject of these use instructions, has been CE certified as a Cat 3 PPE as per
MILAN, Notified Body 0426. The CE marking means the respect of the essential Health and Safety requirements contained in Annexe II of the
following the CE mark identifies ITALCERT, the Notified Body responsible for Quality Assurance Control according to the
Declarations of conformity may be downloaded from our website:http://kasco.eu/download-pdf/download-category/eu-declaration-of-conformity/
---------------------------------------------------------------------------------------------------------------------------------------------------
NOTES:
Operating temperature range
Operating humidity range
Charging temperature range
Equipment run time
BATTERY CHARGERS INSTRUCTIONS USE
Type of Battery Battery
battery model charger model
LI-870
Rechargeable
LITHIUM cod.0105079
8700 mAh
Ni-Mh
Rechargeable
Ni-Mh cod.0105083
3000 mAh
ISTRUZIONI D'USO – USE INSTRUCTIONS –
GEBRAUCHSANLEITUNG – MODE D'EMPLOI -
STORAGE
TEMPERATURE -
minimum/maximum
Year of PRODUCTION
DISPOSAL - diversified
From 0°C to 40°C
From 0°C to 80%
From 0°C to 40°C
Below 0°C and above 40°C the battery may not accept charge
See table at point 2.2
The equipment run time is strongly influenced by the conditions of the filter and other factors. The run time specified in the table at
point 2.2 assumes operation with clean filters and fully charged batteries. Different conditions will produce varying run times.
Inlet voltage Charging
[V] current
[A]
LI-02, 110-220V
3
50-60Hz
Z15, 110-220V
0,5
50-60Hz
para o uso
Product name and code
Reference standard
b) Example of the label affixed to blower units:
c) Example of label affixed to batteries:
d) Example of label affixed to filters:
10 TRANSPORT
The powered respirator is to be kept in its original packaging during transport.
11. STORAGE
Store powered respirators and filters in their original packaging at a temperature
between 0°C and +40°C and a humidity lower than 80%.
12. WARNING
12.1 BEFORE USE CHECK THAT PRODUCT CODE NUMBERS, TYPE AND
QUANTITY OF SUB ASSEMBLIES CORRESPOND TO THOSE LISTED ON THE
RESPIRATOR COMPOSITION CHART.
12.2 Kasco retains any type of warranty forfeited on the instant and declines any liability
either direct or indirect should our Use and Maintenance instructions not be adhered
to and should filters and spares other than genuine Kasco filters and spare be used.
12.3 The liability for the proper operation of the respirator is irrevocably transferred to the
respirator purchaser or operator if:
a) the prescribed maintenance is not carried out and/or repairs and maintenance
are carried out on the respirator Sby personnel not employed by or service
centres not authorized by KASCO.
b) the respirator is used in a manner not conforming to its intended use as specified
in the relative product certification/approval.
12.4 IMPORTANT:
Adhere strictly to all instructions, labels and limitations pertaining to this equipment. If
instructions and warning are not adhered to at all times, respirator effectiveness will
diminish and wearer protection will be reduced.
Regulation (EU) 2016/425 and successive modifications by ITALCERT, Viale Sarca, 336 - 20126

Short circuit cut off device.

Automatic switch over for charge maintenance when battery reaches 90% of its
Charging
charge(GREEN LED).
time 
Environment temperature compensation device.
[h]
USE INSTRUCTIONS

Plug the battery charger into mains.
< 3

Connect battery charger outlet plug to the discharged battery.

Battery recharging is automatic. ( RED LED)

The battery charger may remain plugged into the fully charged battery with no
< 7
overcharge risk provided it be under tension.
CAUTION:
 Store in a dry place.
 Use only genuine Kasco spare parts.
IST-USO-0906005
Rev. N. 0 del 31/01/2020
Pag.6 di 16
Company logo
Serial number
Regulation (EU) 2016/425. The number 0426
Regulation (EU) 2016/425.
IDP107