Advertisement
TSB: 0003-D
TECHNICAL SERVICE BULLETIN
HELIOS
PROGRAMMING INSTRUCTIONS
Remote Pairing.
3
a
Add Remote to Solar Station.
Hold the CONTROL button for 2 sec.
i
Red LED indicator will blink ONCE.
Hold STOP for 2 sec.
ii
Red LED indicator will blink 3 TIMES.
Remote is now paired to solar station
Motor Limits
4
Lower Settings
a
Insert the Black limit tool supplied into the hole with the
i
arrow point up (red).
ii
Press the DOWN button to roll the shade down, the shade
will roll down a few feet and stop. This should happen on
its own. If it does not:
Upper Settings
b
Insert the Black limit tool supplied into the hole with the arrow pointing down (white).
i
Turn the limit tool CLOCKWISE 10 times.
ii
During step
upper limit. If you have to stop the shade before it reaches the top, roll the shade back
down a few feet and start back at previous step.
Press the UP button to roll the shade up.
iii
The shade will roll up and stop.
Once the shade stops turn the limit tool COUNTER CLOCKWISE
iv
to make the shade inch up to your desired upper limit.
1250 | FEB 2021 | TSB 0003-D QUICK START GUIDE
DATE
3/15/2021
TSB TYPE
Quick Start Guide
SHADE TYPES
ALTERNATE TO THE BLACK TOOL: 4mm Allen wrench – black tool is included in Helios Box.
Turn the limit tool CLOCKWISE a few turns.
Press the UP button to roll the shade up
about a foot and press the STOP button.
Next, press the DOWN button to roll the
shade back down and the shade will stop
short of where it did before.
iii
be ready to stop the shade in case the shade doesn't stop at the desired
DESCRIPTION
Helios Quick Start Guide
All Exterior Shades
Switching Direction
b
Ensure the motor direction is correct. When
pressing down, the shade should got down. If
the shade goes up you must switch directions.
Hold the CONTROL button for 10 sec.
i
Red LED indicator will blink 3 TIMES.
STOP
Directions have now been switched.
TSB Number
0003-D
PAGE
MARCH 2021
2 OF 2
Advertisement
