Table of Contents
Advertisement
Available languages
Available languages
4.2 Safety Precautions
The operations for assembly and disassembly of
the appliance are reserved for specialist techni-
cians only.
It is recommended to make sure about their
qualifications and their actual capacity.
For Italy, these technicians must be in
possession of the letter "C" qualifica-
tion issued by the chamber of com-
merce on the basis of Italian Ministerial
Decree 37/08.
The person in charge of the installation, before
starting assembling or disassembling the ma-
chine, must comply with the safety precautions
required by law and in particular to:
• do not operate in adverse working conditions;
• they must operate in perfect psychophysical
conditions and must check that the personal
protective equipment is intact and functioning
perfectly;
• they must wear gloves and safety shoes;
• they must make sure that the area involved in
the assembly/dismantling phases is free from
obstacles.
4.3 Place of installation
For the minimum distances expressed in cm
that must be respected in the positioning of the
product with respect to flammable materials and
objects, refer to the product manual delivered
that accompanies the appliance.
Floors made of flammable material such as wood,
parquet, linoleum, laminate or covered with car-
pets must be protected by a fireproof base under
the appliance that also protects the front part
from the possible falling of combustion residues
during cleaning.
The manufacturer declines all responsibility for
any variations in the characteristics of the mate-
rial constituting the floor under the protection.
Provide a technical space accessible for
any maintenance.
Please remember to respect the minimum dis-
tance from flammable materials stated on the
id plate of the tubes used to manufacture the
fireplace.
26
5
InSTAllATIon
5.1
General considerations
In the following paragraphs there are some
guidelines to follow in order to obtain the maxi-
mum performance of the product purchased.
The following instructions are never-
theless subject to compliance with any
national, regional and municipal laws
and regulations in force in the country
where the product is installed.
Before proceeding with installation of the appli-
ance and the execution of the lining, it is neces-
sary to carry out the following checks:
• check the correct operation of the bypass valve.
5.2 Dry positioning
It is recommended to dry pre-install the ap-
pliance in order to verify the dimensions of the
various components and air intakes.
It is necessary to align the front part of the ap-
pliance with the internal edge of the marble top,
leaving a gap of 5 mm to allow free expansion of
the appliance (Fig. 5).
max. 5 mm
min. 5 mm
min. 10 mm
The image is purely indicative.
L'immagine è puramente indicativa.
Fig. 5
004778411 - 18/09/2020
Advertisement
Chapters
Table of Contents
