Assembly - Cala C14724WB Owner's Manual & Safety Instructions

ASSEMBLY INSTRUCTIONS
Read the "IMPORTANT SAFETY INFORMATION" section
before starting any assembly.
NOTE: Unless otherwise stated, the connections are made using Bolts, Washers and Nuts (W).
NOTE: Finger tighten all connections until assembly is completed, then tighten all bolts/nuts.
NOTE: Assemble workbench on a hard, level, flat surface.
STEP 1:
Attach Side Beams (D x 2pc) to Lower Section of Front (A x 2pc) and Back Posts (B x 2pc).
NOTE: Back Post are longer with 6 holes on top.
Front Post are shorter with 4 holes on top.
STEP 2:
Attach Rubber Feet (C x 4pc) to bottom of each post.
Figure A
Visit our website at: http://www.calaindustries.com
CALA Industries, INC. Copyright 2015 All Rights Reserved Item #C14724WB
©
4