Table of Contents
Related Manuals for First Choice KME6
Summary of Contents for First Choice KME6
- Page 1 SPARE PARTS DIAGRAM FOR Combination Oven KME6 (1551260) First Choice Group Blakeney Way, Kingswood Lakeside Cannock, Staffs, WS11 8LD TEL: 01543 577778 FAX: 01543504141 Email: enquires@firstchoice-cs.co.uk Web: www.firstchoice-cs.co.uk...
- Page 2 KONVEKTOMAT KME6 (1551260) Seznam náhradních dílů / Spare parts list Control panel membrane / sticky foil overlay. Part number 30502900008 FIRSTCHOICE CATERING SPARES 01543 577778 Bc. Sukač...
- Page 3 KONVEKTOMAT KME6 (1551260) Spare parts list / Seznam náhradních dílu 1 45001101000S01P KME6-01-00a Vnitřní bedna - KME 6 2 45001002010001P KME6-02-01a Bedna s izolací-přední plech 3 45001002020000 KME6-02-02 Bedna s izolací-podpěra přední 4 45001002020001 KME6-02-03a Bedna s izolací-držák izolace 5 45001002040200 KME6-02-04 Bedna s izolací-plech izol.
- Page 4 INSTALLATION INSTRUCTIONS SAFETY INSTRUCTIONS USER INSTRUCTIONS STEAM COMBI OVEN MODEL : KME 6 ELECTRIC (6 GRID) MODEL : KME 10 ELECTRIC (10 GRID)
-
Page 5: Site Preparation
SITE PREPARATION REMOVE THE PROTECTIVE PLASTIC COATING FROM THE OVEN CLEAN UNIT WITH SOAPY WATER 1 x WATER CONNECTION WITH ¾ VALVE (UNIT SUPPLIED WITH 1 x Y PIECE CONNECTOR) (AND 2 x ¾ HOSES) A DRAIN PIPE WITH TRAP – 1½” Dia (38mm) ... -
Page 6: Installation
INSTALLATION Place the oven on a level surface allow a clearance between the wall and the unit of at least 5cm. N.B. The control panel should not be next to a heat source. ELECTRICAL CONNECTION This unit must be installed by a qualified electrician. ... - Page 7 Please read instructions before operating this appliance and retain for future use. ALWAYS Do not use this appliance for other Ensure that hands are dry before than intended use. handling the KME 6 and 10 isolators switching Do not immerse the appliance or appliance.
-
Page 8: Cleaning Instructions
CLEANING INSTRUCTIONS Isolate the appliance from the electrical supply before carrying out any maintenance. Keep the oven clean. Do not wash the appliance with high pressure water jets. Do not use steel wool pads or metal scrapers, which could deposit small ferrous parts that might rust. -
Page 9: Control Panel
CONTROL PANEL 1. MAINS SWITCH 2. COOKING SELECTOR a) Combination cooking b) Convection cooking c) Super Steam cooking d) Cooling mode 3. INCREASE/DECREASE OF SELECTED VALUES. 4. TIME/PROBE SET 5. TEMPERATURE SET 6. STEAM ADDITION 7. REGENERATION 8. CYCLE START 9. - Page 10 USER INSTRUCTIONS KME 6 AND KME 10 SWITCH ON TURN MAIN SWITCH TO POSITION 1 AND THEN PRESS BUTTON WAIT 5 SECONDS BEFORE SELECTING THE COOKING FUNCTIONS *NOTE* TO STOP THE COOKING CYCLE AT ANY TIME PRESS START/STOP CYCLE BUTTON CONVECTION COOKING “DRY HEAT COOKING WITH FAN”...
- Page 11 DURING THE CONVECTION COOKING MODE PRESS STEAM ADDITION BUTTON TO SELECT THIS OPTION (WHEN USED ONLY ONE INJECTION OF STEAM WILL BE INJECTED INTO OVEN). COMBINATION COOKING (STEAM) WITH ADJUSTABLE TEMPERATURE SELECT COMBINATION COOKING MODE BY TURNING THE MODE SELECTION KNOB ...
- Page 12 SELECT COMBINATION COOKING MODE BY TURNING THE MODE SELECTION KNOB. PRESS TEMPERATURE SET BUTTON AND WITH ADJUSTMENT DIAL SELECT REQUIRED TEMPERATURE.(See item 3 on the control panel key guide) (PRE-SET 0°C) (0 – 100°C) PRESS START/STOP CYCLE BUTTON TO START COOKING WITH CORE PROBE ...
-
Page 13: Technical Data
TECHNICAL DATA KME 6 KME 10 VOLTAGES SINGLE 230v AC SINGLE 230v AC 3 PHASE 400v AC 3 PHASE 400v AC CAPACITY 6.7KW 13.4KW AMPS SINGLE 30 NOMINAL SINGLE 59 NOMINAL 3 PHASE 5.6 NOMINAL 3 PHASE 11.2 NOMINAL PER PHASE PER PHASE KME 6 KME 10... - Page 14 KME 10...