W+W 78334 Mounting Instruction page 4

1 Intended use
Pit ladder for permanent placement in a pit.
2 Safety instructions
All safety instructions and all safety measures for lift mounting have
to be considered while mounting.
Assembly operations at the lift systems have to be accomplished only
by qualified persons.
If the ladder is mounted in a lift shaft, the ladder and its attachments
must not extend into the moving parts of the lift in the storage position.
The ladder must jut out at least 1.10m beyond the exit, according to
EN81-20.
3 Scope of delivery
x Ladder
x Plastic bag with:
- 4x Fastening angle
- 2x Threaded rod M8 incl. washers and nuts
- 4x Dowels 2x60
- 4x Hexagonal wood screws 0x70
- 4x Washers M0
- 4x Plastic cap nuts
5 Mounting
. Check the scope of delivery.
2. Screw off the outer nuts of both threaded rods and replace the outer washers.
3. Slide the threaded rods through the second ladder rung from the bottom and from the
top of the ladder.
4. On each side two washers must be placed inside of the rung, in order to make sure
that the ladder does not shift on the threaded bolt.
© W W 09/205 Version 0
+
ID32768
4