Unpack CB
• Ensure only qualified personnel install, operate, service, and maintain all electrical
equipment.
Falling Object
• Ensure lifting equipment has capability for device being lifted.
• Wear hard hat, gloves, and safety shoes.
• Failure to comply with these instructions could result in serious injury.
•
A factory-installed rejection feature prevents mismatching circuit breakers and cassettes/
substructure, preventing the insertion of a circuit breaker with a lower rating into a higher rated
cassette/substructure, or the insertion of a higher rated circuit breaker into a lower rated
cassette/substructure.
By following the procedures below, you should be able to install the breaker with minimum effort
and time.
EntelliGuard R Circuit Breaker Retrofill AKD-10 Installation Manual
14
• Turn off all power to switchgear. Tagout
and lockout main source, up-stream or main
breaker.
• Failure to comply with these instructions
will result in death or serious injury from
severe burns caused by arc flashing that has
exceedingly high temperatures.
•
Always wear personal protection equipment
according to OSHA standards and
appropriate to the severity of potential
burns.
•
Do not walk or remain under any heavy assembly while
hoisted above head as the chains securing the
assembly may give way
PRODUCT DAMAGE
• Ensure circuit breaker and its accessories
are always used within their designated
ratings.
• Do not allow the circuit breaker to hit a
hard surface while handling.
•
Do not drag or slide the circuit breaker
across a hard or rough surface
DEH41550 R06