TP-Link Nano Manual

Download this manual

How to connect TP-Link Nano Router to WiFi-Router

1. Turn on TP-Link Nano Router by connect USB with Adapter or connect with Notebook

2. Connect TP-Link Nano Router WiFi

3. After connected, Fix IP Address at Notebook is in a same network with TP-Link Nano Router

- Default IP Address:

- Fix IP Address:

- Subnet Mask:

- Default Gateway:

192.168.0.254

192.168.0.xxx

(any IP Address)

255.255.255.0

192.168.0.1

Page 1 1. Turn on TP-Link Nano Router by connect USB with Adapter or connect with Notebook 2. Connect TP-Link Nano Router WiFi 3. After connected, Fix IP Address at Notebook is in a same network with TP-Link Nano Router - Default IP Address: 192.168.0.254...
Page 2 4. Open browser then access default IP of Nano Router: 192.168.0.254 via using default Username and Password - Username: admin - Password: admin...
Page 3 5. Click Quick Setup > Next 6. Select Repeater Mode > Next 7. Click Survey to find a Wi-Fi name which you want to connect.
Page 4 8. Then will be show a Wi-Fi which found in the area then select a Wi-Fi which you want to connect by click Connect 9. SSID will be show automatic then fill the password that you setting but need to know which encryption? (following below) WEP(ASCII) WEP(HEX)
Page 5 10. Click Reboot and wait till reboot completed 11. Then use Notebook connect with Wi-Fi that you choose for access TP-Link setting page. 12. Click LAN > Fix IP Address in a same network with Wi-Fi Router (Exp: 192.168.1.60) then click Save to Restart...
Page 6 13. Removed the IP Address that you fixed at notebook then try access TP-Link by New IP Address that you set up and fill a default username and password for checking and investigate can work or not? - Username: admin...
Page 7 How to reset all setting of TP-Link Nano Router - Use pen or small thing press continue into a hole until light down and up.