Setup Of Outputs Out1, Out2; O1: Output 1 Function Setting; O2: Output 2 Function Setting; Rf: Fault And Warning Log Reset - DAB PUMPS PWM 203 Instruction For Installation And Maintenance

13
6.6.14

Setup of outputs OUT1, OUT2

This section illustrates the functions and possible configurations of the outputs OUT1 and OUT2 via parameters O1 and O2.
For electrical connections, see section 2.2.4.
The default settings are those in Table 27.
6.6.14.1

O1: Output 1 function setting

Output 1 notifies of an active alarm (i.e. that there is a system block). The output enables use of a normally closed or normally open
voltage-free contact. Parameter O1 is associated with the values and functions specified in Table 28.
6.6.14.2

O2: Output 2 function setting

Output 2 notifies of electric pump running status (pump on/off). The output enables use of a normally closed or normally open
voltage-free contact. Parameter O2 is associated with the values and functions specified in Table 28.
Output
configuration
Activation conditions
No function
0
associated
No function
1
associated
Presence of blocking
2
errors
Presence of blocking
3
errors
6.6.15

RF: Fault and warning log reset

To clear the fault and warning log, press and hold the buttons + and – simultaneously for at least 2 seconds. The number of faults
present in the log (max. 64) are summarised below the RF symbol.
The log can be viewed from the MONITOR menu on the FF page.
6.6.16 PW: Password settings
The inverter is equipped with a password protection system. If a password is set, the inverter parameters will be accessible and
readable, but no modifications are admitted.
When the password (PW) is "0" all parameters are unlocked and can be modified.
on input (NO)
Active with low signal on
input (NC)

Table 26: Low pressure signal detection (KIWA)

Output
OUT 1
OUT 2

Table 27: Default output settings

Configuration of functions associated with outputs
OUT1
NO contact always open,
NC contact always closed
errors NO contact closes
and NC contact opens
errors NO contact opens
and NC contact closes

Table 28: Output configuration

ENGLISH
System block due to low pressure
Present
System block due to low pressure
Absent
Present
Default output settings
Value
2 (fault NO closes)
2 (Pump running NO closes)
Output contact status
NO contact always
closed, NC contact
always open
In event of blocking
In event of blocking
111
on intake.
Manual reset
on intake.
Manual reset
Normal
OUT2
Activation conditions
No function NO contact always open,
associated NC contact always closed
NO contact always
No function
closed, NC contact
associated
always open
When the pump is
Activation of output in
running, the NO contact
event of blocking
closes and the NC
errors
contact opens
When the pump is
Activation of output in
running, the NO contact
event of blocking
opens and the NC
errors
contact closes
F4
F4
None
Output contact status