TC-Helicon VOICETONE HARMONY-G XT Quick Start Manual page 2

Preset A/B footswitch – Tapping the
(12)
footswitch will toggle between the presets
assigned to slot A and B. Hold the footswitch
to enter Preset Select mode for the current
slot (A or B), which allows the footswitch to
cycle through all 5 saved presets.
On/Bypass footswitch – Tapping the
(13)
footswitch engages or disengages the
doubling and harmony effects in the current
preset, leaving the reverb/delay effects
active. Holding the footswitch will enter
Tuner/Bypass mode, which mutes the guitar
signal and bypasses all vocal effects except
for Tone.
USB port – Connect to a computer for
(14)
firmware updates and support.
Power input – Connect the included power
(15)
adapter. (12 V DC, 300 mA, tip negative)
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon
any description, photograph, or statement contained herein. Technical specifications, appearances and other information
are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,
Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera and Coolaudio are trademarks or
registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2019 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe's Limited Warranty,
please see complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South China Modern Chinese Medicine Park, Nanlang Town,
528451, Zhongshan City, Guangdong Province, China
OUTPUTS – Connect to a mixer
(16)
via XLR cables.
INST IN/THRU – Connect your guitar to the
(17)
IN jack, then connect the THRU to other guitar
pedals or an amplifier.
MIC INPUT – Connect your microphone via
(18)
XLR cable.
GND – If you hear a buzz when you plug
(19)
in a cable from the THRU to your amp or
PA, press this button in. If the THRU jack
is not used and your guitar sound is routed
internally, the Ground Lift switch should be
left out.
Visit tc-helicon.com to download the full manual