Inserting/Changing Battery; Start-Up - Maxx-world Magic Lighting Instruction Manual

Inserting/changing battery

The battery for the remote control has already been
inserted. You only have to remove the transport guard.
1. Push the catch on the battery compartment to the right
using your fi nger nail and pull out the battery compartment
at the same time.
2. Remove the empty battery and dispose of it in an environ-
mentally-friendly manner.
3. Insert a 3 Volt battery of type CR2025. When inserting bat-
teries, always make sure that the polarity is correct (+/–).
4. Place the battery compartment back into the remote con-
trol. It must audibly lock into place.

Start-up

You can screw the LED light into any lamp with the
appropriate socket.
1. Unpack the product contents and remove any protective
foils and stickers. Check all parts for any damages from
transport. Should you identify any transport damages,
please promptly consult customer service.
2. Screw the LED light into a appropriate socket (E27).
3. Turn on the LED light by switching on the light switch of
the lamp and pushing the ON button on the remote control.
4. Select the desired colour or the desired effect and push
the corresponding button on the remote control.
Please note that the colour settings are mixed col-
ours. For this reason, the colour tints may exhibit
minor deviations. Even white light is a mixed colour
and thus not a purely white colour tint!
5. Set the desired colour brightness using the buttons to in-
crease/decrease the intensity of colour.
6. Push the OFF button to turn off the LED light and switch
off the light switch of the lamp.
14