Lifestyle Solutions RETRO BED Assembly Instructions

Parts And Fittings Packing Detail

Box # 1

Page 1 of 2

The Fusion Of Function And Comfort With Style

Box # 2

1 pc. Head Board

1 pc. Foot Board

2 pcs. Bed Side Rails

1 pc. Slat Support

4 pcs. Leg

Support

Optional Slats

13 pcs. Slats

RETRO BED

Hardware Pack in Box #1

Bolt

M8 x 20mm - 4 pcs

M8 x 45mm - 4 pcs

Washer - 12 pcs.

Nuts - 4 pcs.

Bolts M6 x 70mm - 4 pcs.

4mm Allen Key 1 pc.

M4 x 32mm Wood Screw

- 8pcs.

5mm Allen Key 1 pc.

Wrench -1 pc.

Slat Hardware

32mm Screw - 20pcs.

(Wrapped in separate plastic bag)

A complete assembled view of

a Conventional Bed

Table of Contents

Do you have a question about the RETRO BED and is the answer not in the manual?

Page 1 5mm Allen Key 1 pc. Wrench -1 pc. Slat Hardware 32mm Screw - 20pcs. (Wrapped in separate plastic bag) Page 1 of 2 RETRO BED A complete assembled view of a Conventional Bed The Fusion Of Function And Comfort With Style...
Page 2 Diagram 1 Bed Assembly Instructions Step 1/Diagram 1 Head Board Head board RETRO BED Fix both side rails to the Head Board and Foot Board as shown in diagram 1 with the 20mm and 45mm bolts and Through Hole washers.
Page 3 234 Series Casegood Assembly of Metal Drawer Knobs. Step #1 Remove Drawer Knobs as shown To replace Wood knobs with the Metal knobs, remove the Wood knobs and assemble the Metal knobs with the bolts provided along with the Metal knobs. (Do not use Bolts from the Wood knobs on Metal knobs.) Step #2 Assemble knobs on the outside as shown.
Page 4 Center Leg 134/ 234/ 334/600 Series 6 Drawer Dresser Removing of Center Leg slide direction The center Leg is added for additional support. It is an optional extra. You may remove it if you wish, The following steps will assist you in doing this STEP 1 Allen Key...
Page 5 234 Series Casegood Step 1 Fixing of Metal Door Knobs. Remove Door knobs as shown. To replace wood knobs with the metal knobs, remove the wood knobs and assemble/fix the metal knobs with the bolts provided with the metal knobs. (DO NOT USE bolts from the wood knobs on metal knobs) Step 2 Refix knobs on the outside as shown.