General Information; Various Models And Terms - Task Force Tips ThunderFog Series Instructions For Installation, Safe Operation And Maintenance

3.0 GENERAL INFORMATION

This manual describes nozzles calibrated at 100 psi (7 bar) and 75 psi (5 bar). Contact factory for data specifi c to models that operate
with metric fl ow calibrations. Thunderfog, Quadrafog and QuadraCup are economical, lightweight, and dependable nozzles. Their
rugged construction is compatible with the use of fresh as well as fi refi ghting foam solutions. Other important operating features are:
• Quick-acting pattern control from straight stream to wide fog
• Fixed fog teeth
• Stainless Steel spinning fog teeth available on some models
• Easily fl ushable while fl owing to clear trapped debris
• Quick-change rear valve seat
• TFT's fi ve-year warranty and unsurpassed customer service

3.1 VARIOUS MODELS AND TERMS

The nozzle is available in several diff erent models and inlet connections. Basic body styles are shown in fi gure 1.
Selectable Flow: A nozzle with a discharge orifi ce that can be set to a user selected position. In each position the nozzle acts as a
fi xed orifi ce nozzle.
Fixed Flow: A nozzle with a discharge orifi ce that is a fi xed opening size. The user can set the opening to fl ush positions, or on tip
only models to the OFF position.
Tip Only: a nozzle without an integral ball shutoff valve. Thunderfog, Quadrafog and QuadraCup nozzles are available in a variety of
fl ow ranges and confi gurations. All models deliver the selected fl ow when the rated pressure is supplied to the nozzle. Flow settings
and recommended hose sizes are:
SERIES
INCHES
1" QUADRAFOG
1.5" QUADRAFOG
1.5" QUADRACUP
1.5" THUNDERFOG 1-1/2 to 1-3/4
2.5" THUNDERFOG 1-1/2 to 2-1/2
* Other threads, coupling sizes, or connector styles can be specifi ed at time of order.
ThunderFog, QuadraFog and QuadraCup nozzles are available in several models. Some common models are shown in fi gure 1.
Coupling
A) TIP ONLY
(not available with 2-1/2" coupling)
©Copyright Task Force Tips LLC 2002 - 2018
RECOMMENDED
HOSE SIZE
MM
3/4, 1 19, 25
1-1/2 38
1-1/2 38
38 to 45 30, 60, 95, 125, 150, 200
38 to 64 95, 125, 150, 200, 250
Shaper
FLOW SETTINGS
@100 PSI (7bar)
GPM
5, 10, 24, 40
30, 60, 95, 125 115, 230, 360, 475
30, 60, 95, 125 115, 230, 360, 475
115, 230, 360, 475, 550, 750
360, 475, 550, 750, 950
ON
Model Number
Serial Number
Pressure Calibration
5
l/min
20, 40, 100, 150
Selectable Flow, Foam
OFF
Ball Valve Handle
B) BALL VALVE
LKF-100 August 2, 2018 Rev19
NOZZLE TYPE
Selectable Flow
Selectable Flow
Selectable Flow
Selectable Flow