Wire Terminations - ETC SC1008 Branch Circuit Emergency Lighting Transfer Switch Installation Manual

ETC Installation Guide
SC1008 BCELTS
3. Four knockouts are provided on the right side of the enclosure. Install conduit fittings
(provided by others) to the knockout locations.

Wire Terminations

The SC1008 can accommodate installations that require a
power or more complex installations, such as those that utilize an
Switched Load
accommodate installations that utilize
with either normally open or normally closed operation.
WARNING:
power to the panel before working inside could result in serious injury or death.
AVERTISSEMENT :
panneau sans avoir déconnecté le courant peut entrainer des blessures graves,
voire mortelles.
Before you begin pulling and terminating wire to the SC1008 BCELTS enclosure,
make sure the main circuit breaker cabinet or other readily accessible input
power disconnect device for both normal and emergency power input is locked
out and tagged out. Enclosures installed without an accessible input power
disconnect device cannot be serviced or operated safely. Follow all local codes
and restrictions. When the disconnect device is not located near the installed
enclosure, the disconnect must allow for proper lockout/tagout.
Line / Load / Terminals 1–8
Control (signal) / Terminals 9–12
Earth Ground
SC1008 BCELTS
. See the related instruction for your installation type. Additionally, the unit can
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
RISQUE D'ELECTROCUTION! Travailler à l'intérieur du
Wire and Terminal Specifications
Terminal
Simple Transfer
0–10 V Auxiliary Output
Wire Range
10–18 AWG
(copper wire solid/stranded)
10–20 AWG
(copper wire stranded only)
6–14 AWG
(copper wire solid/stranded)
Page 4 of 11
of normal and emergency
ETC Control Panel or a
control and Fire Alarm Input
Strip Length Torque Rating
3/8" (10 mm)
1/4" (6 mm)
3/8" (10 mm)
Dimmed or
for use
10 in–lbs
4 in–lbs
35 in–lbs
ETC