Advertisement
15. Assemble a hitch arm mount bracket to the
axle bracket using two M8×25 carriage bolts (3),
Ø8 lock washers (6) and M8 hex nuts (5). Do not
tighten yet.
16. Insert the lift handle (2) down through the tine
shield. Attach it to the hitch arm mount bracket
just assembled using an M8×20 hex bolt (4) and
an M8 hex lock nut (7). Tighten.
17. Position the hitch arm mount bracket so that
there is side tension on the lift handle (2) with grip
(1) when it is locked in the up position. Tighten
the nuts.
Operation and adjustments
Regular removal of thatch is critical to maintenance of a healthy lawn. Thatch is a layer of stems, clip-
pings, runners, roots and leaves that have not decayed. Excessive thatch prevents air, water and fertil-
izer from reaching the roots. The scarifier effectively dislodges excessive thatch from your lawn. Read
these instructions to help avoid improper adjustment and operation.
Proper adjustment of the tine shield and spring tines is important for effective performance. Refer to
the following steps for the proper adjustment before operating the scarifier.
1. Move the towing vehicle onto a level surface,
such as a driveway or garage floor and attach the
tine scarifier to the vehicle hitch.
2. To adjust the spring tine shield, lower the scari-
fier into operating position using the lift handle (2).
Loosen the two hex nuts and carriage bolts (1)
which fasten the rear of the hitch mount arm to
the hitch arm mount brackets. Adjust the tin shield
until it is level and both the front and rear spring
tines are in contact with the ground. Re-tighten
the hex nuts.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 51705
Page 8
01
2021-1
Advertisement
