Advertisement
Assembly instructions
Tools required for assembly (1 of each):
13 mm wrench
14 mm wrench
Adjustable wrench
Pliers
Before assembling the scarifier, lay out all of the parts and hardware as shown on the previous pages.
The 40" scarifier is show in the following drawings. The assembly of the 40" and 48" is the same ex-
cept as noted in the instructions.
1. Assemble the lift plate (1) to the top of the tine
shield using four M8×20 hex bolts (2) and M8 hex
lock nuts (3) as shown in figure. Tighten.
5. Fasten the hitch mount arms (2) to the outside
of the angle brackets at the front of the tine
shield. Use two M8×20 hex bolts (3) and M8 hex
lock nuts (4). Tighten and then loosen the nuts
slightly.
6. Fasten the hitch mount arms to the outside of
the hitch arm mount brackets (2) at the rear of the
tine shield. Use two M8×25 carriage bolts (1), Ø8
lock washers (6) and M8 hex nuts (5). Do not
tighten yet.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
2. Turn the tine shield upside down.
3. Assemble two (tall) hitch arm mount brackets
(5) and two (short) angle brackets (4) to the bot-
tom of the tine shield. Fasten the brackets to the
four round holes at the rear of the tine shield us-
ing four M8×20 hex bolts (3) and M8 hex lock
nuts (1). Do not tighten yet.
4. Assemble two angle brackets (4) to the round
holes in the bottom of the tine shield at the front.
Use two M8×20 hex bolts (3) and M8 hex lock
nuts (1). Do not tighten yet.
Item 51705
Page 6
01
2021-1
Advertisement
