Advertisement
Quick Links
Operation Manual
Mower Tractor Scarifier 100 cm
51705
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 51705
Summary of Contents for WilTec 51705
- Page 1 Operation Manual Mower Tractor Scarifier 100 cm 51705 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 40” scarifier, it is recommended that another adult be present to assist with the assembly. INSPECT ALL COMPONENTS closely upon receipt to make sure no components are missing or damaged. © by WilTec Wildanger Technik GmbH Item 51705 Page 3 http://www.WilTec.de...
- Page 4 CAUTION Read and follow all instructions for assembly and operation. Failure to properly assemble this equipment could result in serious injury to the user or bystanders, or cause equipment damage. © by WilTec Wildanger Technik GmbH Item 51705 Page 4 http://www.WilTec.de...
- Page 5 K Lock washer Ø8 Carriage bolt M8×25 Big flat washer Ø8 Hitch pin Ø10 M Angle bracket Hair cotter pin Ø3 N Hitch arm Mounting bracket © by WilTec Wildanger Technik GmbH Item 51705 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 6 (2) at the rear of the tine shield. Use two M8×25 carriage bolts (1), Ø8 lock washers (6) and M8 hex nuts (5). Do not tighten yet. © by WilTec Wildanger Technik GmbH Item 51705 Page 6 http://www.WilTec.de http://www.aoyue.eu...
- Page 7 Bend the ends of the wires to se- cure them. © by WilTec Wildanger Technik GmbH Item 51705 Page 7 http://www.WilTec.de http://www.aoyue.eu...
- Page 8 Adjust the tin shield until it is level and both the front and rear spring tines are in contact with the ground. Re-tighten the hex nuts. © by WilTec Wildanger Technik GmbH Item 51705 Page 8 http://www.WilTec.de http://www.aoyue.eu...
- Page 9 3. If rust appears on the shield or spring tines, sand lightly and coat with enamel paint. 4. Always store in a dry area, and coat exposed metal with light oil when not in use. © by WilTec Wildanger Technik GmbH Item 51705 Page 9 http://www.WilTec.de...
- Page 10 24 Hair cotter pin Ø3 Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 51705 Page 10 http://www.WilTec.de...