Advertisement
- -
Placement
Now that setup is complete, you must choose a location to place the
wireless sensor and the dis(?lay unit. The wireless sensor MUST be
placed less than 165 feet (50 meters) away from the display unit.
This wireless forecaster uses radio frequency for communication, which
is susceptible to interference from other electronic devices and large
metallic items or thick walls. Always place both units at least 3 feet (. 91
m) away from a.e.pliances ( TV, microwave, radios, etc. ) or obiects that
may interfere w1tli the wireless communication ( large metal surfaces,
thick stone walls, etc. ).
--'o'' ....
; I \'
AT
ILEASTI
)}})
{{((
~
3
feet
1.91
ml
APART
~,
[165 feet maximum]
[50
meters]
~,,. Placement of Display Unit
Place the display unit in a dry area free of dirt and dust. To
help ensure an accurate indoor temperature measurement, be
sure to place the display unit out of direct sunlight, and away
from any heat sources or vents in your home. There are 2
placement options for the display unit. You may hang the
display unit on a wall using the integrated hang hole.
Alternatively, you may place the display unit on a table top or
other flat surface using the integrated fold-out table top
display stand.
Placement of Sensor
The wireless sensor MUST BE PLACED OUTDOORS to observe
outdoor temperatures. The wireless sensor must be placed less
than 165 feet (50 meters) from the display unit. The wireless
sensor is water resistant and is designed tor general outdoor
use. However, to extend the life of tne product, place the
wireless sensor in an area protected from direct weather
elements. To ensure an accurate outdoor temperature
measurement, be sure the wireless sensor is placed out of
direct sunlight and away from any heat sources.
There are 2 placement options for the wireless sensor. You may
hang it using one of the two integrated hang holes, or use
string (not included) to hang it from a suitaole location like a
well covered tree branch.
4
TROUBLESHOOTING
Problem
Possible Solution
Bad
Wireless Sensor
Reception
Ti
I ll
no bars
Relocate the display unit and/or the wireless
sensor. Both units must be within 165 feet (50
meters) from each other. Make sure both
units are placed at least 3 feet (.91 m) from
other electronic appliances and devices that
may interfere with the wireless
communication (such as TV's, microwaves,
computers etc). NOTE: It may take up to 20
minutes for the display unit to re-synchronize
with the sensor when batteries are replaced.
Use lithium batteries in sensor when
temperature is below -4°F (-20°C).
Bad
Atomic Clock
Reception
no
bars
Too~~
Rotate the wireless sensor 90° on its mounting
point. Make sure the main unit and wireless
sensor are placed at least 3 feet (.91 m) from
other electronic appliances and devices that
may interfere with the wireless communication
(such as TV's, microwaves, computers etc).
Large metallic surfaces will interfere with the
atomic clock signal.
Display Unit
Screen Not Working
Batteries may need replacing
Check that batteries are correctly installed
5
Advertisement
