Advertisement
SETUP
Battery Choice
&
Temperature Range
Extended periods of cold temperatures ( below -4°F / -20°C ) can cause
alkaline batteries to function improperly. This will cause the outdoor
wireless sensor to stop transmitting temperature readings. Use lithium
batteries
in
these low temperature conditions to ensure continued
operation for wireless sensors placed outdoors.
B~ff~~~"
tt•W#i·H•
(700C)
158°F
I
ALKALINE
BATTERIES
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY
Clean
contacts
prior to battery
Remove battteries from
SAFETY: the battery
and also those of the device
installation.
equipment which is not to be used for an extended perid of lime. Follow the polarity(+/·) diagram in the battery compartment.
Promptly remove d ead
batteries from the device.
of used
properly.
of the same
type as recommended
DO
Dispose
batteries
Only batteries
or equivalent
are to be used. NOT
incinerate used batteries. DO NOT d ispose o f batteries in fire. as batteries may explode or leak. DO NOT m ix old and new batteries or types of batteries
use
batteries. NOT
non-rechargeable
DO
short-circuit
(alkaline/standard).
DO NOT rechargeable
DO
recharge
batteries. NOT
the supply terminals.
Installing Batteries - Wireless Sensor
Remove the battery
compartment cover.
Install 2 fresh "AA"
batteries as shown here.
BATTERIES MUST BE
INSTALLED FOR THE
SENSOR TO OPERATE
Installing Batteries - Display Unit
Remove the battery
compartment cover.
Install 2 fresh "AA"
batteries as shown
here.
2
SETUP
About the Self Setting Atomic Clock
A clock is considered atomic if it has an accuracy of one second in a
million years. Consumer clocks are considered atomic if they attain this
accuracy by receiving a signal from an atomic clock. In North
America, the National Institute of Standards and Technologies
operates an atomic clock in Colorado which transmits the time codes
via the radio station WWVB. The Acurite clock you have purchased
includes a built-in receiver which picks up the signal from the WWVB
station. For the best possible reception, place the display unit with the
back side facing Colorado. NOTE: Due to solar radiation in the
atmosphere, the atomic clock signal is weaker during the day. Most
synchronization with the WWVB atomic clock signal happens at night
when there is less interference.
Display Unit : Basic Setup
Press the "SET" button to enter into set mode. The time zone (next to
the clock display) will begin blinking.
To adjust the currently selected (flashing) preference item, press the
" ... " or "...,." buttons.
To save your adjustments, press the "SET" button again to move on to
adjusting the next preference. The preference set order is as follows:
TIME ZONE ( PST MST CST EST AST HAST AKST)
DST (Daylight Saving Time ON or OFF)
CLOCK HOUR
CLOCK MINUTE
CALENDAR MONTH
CALENDAR DATE
CALENDAR YEAR
You will automatically exit SET MODE if no entries are changed for 30
seconds. You may enter basic setup mode again at any time by
pressing the "SET" button.
TO SELECT EITHER °FOR °C TEMPERATURE UNITS:
Press the " ... " button while in normal display mode (NOT in "SET"
mode).
3
Advertisement
