Work Station Safety - Technifor XM700 Operating And Maintenance Manual

5. Work station safety

To ensure security and productivity, read this manual before starting-up the equipment.
Instructions for use and warranty limitations
This equipment is designed to mark material using Technifor electromagnetic styli only. Any other use,
or the use of styli other than those provided by Technifor is not recommended. Technifor will not be held
responsible for the results.
• This marking equipment is designed to function at a room temperature between 5
(see: Technical specifications). The relative humidity level must be between 20 and 90% (without
condensation).
• Never disconnect the cable connecting the power supply to the marking gun when the power supply is switched
on.
• Never disconnect the battery when the machine is switched on.
• Grounding must be done according to the regulations in effect to ensure the safety of the personnel. The con-
nection to the single phase power supply is made with a standard, 3 pin plug with grounding. It must be equip-
ped with an adequately calibrated 30 mA differential cut-off and protection device.
• This marking equipment is not designed to operate in damp premises. This marking equipment is not designed
for use in rain.
• Never lubricate any elements of the stylus.
• Do not use this marking equipment in an explosive environment.
• During marking, do not place fingers or objects in the area reserved for stylus movement. Keep hands away
from the marking area. Disregard for this recommendation may result in the operator being lightly pinched by
the point of the stylus.
• Only use the touch screen with the finger (gloves may be worn) or the screen pen provided by Gravotech. To
prevent damage to the screen, avoid the use of pointed objects or of another stylus.
• Clean the screen with a soft dry cloth. To avoid scratching the screen, do not use liquids or abrasive materials.
• When connecting, press the connector(s) until you hear a click.
• Use the handles for carrying and handling the machine. Never lift the machine by the cord.
When marking or doing test marking, the stylus must always hit a part.
If it strikes only air, these are the risks:
• mechanical deterioration of moving parts
• void of the manufacturer's guarantee
Gravotech will not be held responsible for injuries resulting from disregard for the above operating instructions or
other general safety rules applicable to the use of this equipment or resulting from misuse. Furthermore, disregard
for the instructions will void the warranty.
Ref. 72523 - XM700_en_B
Introduction
A
0 0 0
C (41 F) to 45 C (113
A
0
F)
6/23