Every Year; General Maintenance - Technifor XM700 Operating And Maintenance Manual

2. Every year

Have the marking head serviced by Gravotech.
This operation includes:
• complete dismantling of the machine
• cleaning of the mechanical elements
• replacement of the point and its spring
• verification of the condition of the motors and the belt
• reassembly and adjustment of mechanical elements
• debugging of the head in an enclosure
• marking tests
This maintenance list was established based on a marking frequency of:
• 1 cycle(s) every 2 minutes
• 15 characters 3 mm (0.118 in) high per cycle
• 8 hours of operation per day on 50 DaN/mm
During servicing of the marking head, Gravotech can provide identical rental equipment so that production is not
interrupted.

3. General maintenance

Maintenance consists of regular monitoring of marking quality. Intensive use of the equipment can impact the
guiding systems of the carriage or the stylus point, and may result in distortion of the characters.
Contact your distributor to schedule an appointment for servicing. This "tune-up" does not take a long time.
When removing/replacing the end of the stylus, check that there are no hard
impurities on the male and female threads, to prevent the assembly from seizing up.
Ref. 72523 - XM700_en_B
Preventive maintenance
A
2
(72518.869 lb/in
2
) steel
D
19/23