Page 1
HA - 240 Lite V5 HA - 280 PRO HA - 280 PRO INSTALLATION MANUAL INSTALLERʼS MANUAL INSTALLERʼS MANUAL HA - 280 PRO INSTALLERʼS MANUAL Manufacturer: Manufacturer: Manufacturer: COMMERCIAL ELECTRONICS CO. LTD COMMERCIAL ELECTRONICS COMMERCIAL ELECTRONICS 264 HAYDONS ROAD, WIMBLEDON, LONDON SW19 8TT, UK 264 HAYDONS ROAD, WIMBLEDON, LONDON SW19 8TT.
Installation points to remember This product represents many years of research and development. It is very sophisticated and should be installed by experienced security installers only. Please do not attempt installation of this product without reading this guide. The system has been designed to provide the ultimate in security, coupled with limitless convenience and expansion options.
Locations for the control box Some things to remember about where to mount the control module: • Never put the control module in the engine compartment! • The first step in hot wiring a vehicle is removing the driver’s side under-dash panel to access the starter and ignition wires.
Page 5
Locations for the Hawkguard Locations for the Hawkguard ultra sonic sensors Locations for the Hawkguard ultra sonic sensors ultra sonic sensors Ultrasonic cells should be placed on the left and right side as high as possible so to obtain the Ultrasonic cells should be placed on the left and right side as high as possible so to obtain Ultrasonic cells should be placed on the left and right side as high as possible so to obtain the best performance.
Finding the 12v switched ignition wire The ignition wire is powered when the key is in the run or start position. This is because the ignition wire powers the ignition system (spark plugs, coil) as well as the fuel delivery (fuel pump, fuel injection computer).
Finding the door Pin Switch Circuit The best places to find the door switch wire are: • At the pin switch: when testing the pin switch, check wire to ensure that it ‘sees’ all the doors. Often, the passenger switch will cover all the doors even if the driver’s switch will not.
Page 8
Primary harness wire connection guide for 24 pin connector This guide describes in detail the connection of each wire. Also included are possible applications of each wire. This system was designed with the ultimate in flexibility and security in mind. Please read the instructions carefully to ensure a thorough understanding and how it operates;...
Connect to first accessory of ignition switch (+12v). Pin 87a and 30 of relay 2 x GREEN WIRES: Normally closed, can be connected to starter motor, positive side of coil, for diesel car fuel pump. See wiring diagram for guidance.Connected to Hawk Motorcycle Alarm...
Siren connection guide Siren connection guide Siren connection guide RED WIRE: RED WIRE: Connect to battery direct or constant 12v power supply. RED WIRE: Connect to battery direct or constant 12v power supply. Note: Use 7.5 amp fuse (not supplied). Siren connection guide Note: Use 7.5 amp fuse (not supplied).
Bonnet and door protection Bonnet and door protection Bonnet and door protection Bonnet and door protection Optional diode and BLUE WIRE (–) INPUT FROM ALARM bonnet pin switch Optional diode and BLUE WIRE (–) INPUT FROM ALARM Optional diode and BLUE WIRE (–) INPUT FROM ALARM not included bonnet pin switch...
Page 19
C O N S U M E R WAR RA NTY Product), excluding accessories, purchased and installed from a Commercial Electronics authorised of one year. warranty service, the Product must be returned to a Commercial Electronics authorised dealer along Note: This warranty does not cover subscriber agreements or failure of services provided under the terms Purchaser is required to enter separate subscriber contracts in order to receive these services.