Table of Contents
Advertisement
Instruction Manual
INSTALLATION
- Please read the safety instructions in this manual completely before installation.
- Install your TV in an area where direct sunlight will not fall upon the screen.
- Soft, indirect light is best for television viewing.
- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper
ventilation.
- Optimum television viewing distance is 3-5 times the screen's size.
Auto-Degaussing
Color television can be easily affected by magnetism, which shows as color distortion on the screen. If
your TV is affected by nearby magnetic components or appliances, turn it off for a few minutes. The
built-in auto-degaussing circuit will eliminate the magnetic interference.
Auto off when no signal received
The TV set will automatically enter into Standby mode when the following conditions are met.
1.TV is in antenna mode.
Connecting the Antenna
VHF
UHF
or Cable
VHF
UHF
Notes:
1. It is recommended that a 75 ohm coaxial cable be used in
order to
eliminate interference and noise which may occur due to
nearby radio
transmissions.
2. The antenna cable should not be tied together with other
wiring.
Installing the Remote Control Batteries
3. Set up a lightning rod and check it regularly when an outdoor
antenna
is used.
1. Remove the battery compartment lid.
2. Insert two AAA batteries (included). Make sure the positive
(+) and negative (-) polarities are correctly aligned.
3. Reattach the battery lid.
75-ohm coaxial cable (not supplied)
OR
300-ohm twin-lead cable (not supplied)
Antenna adapter
(not supplied)
OR
U/V mixer
(not supplied)
7
RF Input
(back of TV unit)
Hide quick links:
Advertisement
Table of Contents
