Table of Contents
Advertisement
Pump/Motor
Refer to the manuals provided by the pump and motor manufacturer for maintenance
instructions for the respective components. This can be located in the document holder
connected to the frame on the front of the Water Trailer
• Never run the Motor and Pump for long periods of time without water in the system.
Operating the Pump and Motor while the system is empty may result in damage to the
Pump seals or impeller. When the Water Trailer is empty shut off the Motor to prevent
any damage to the Pump and Motor.
• Always use a gas stabilizer in the gas used in the motor for the Water Trailer. Failure to
use gas stabilizer in the fuel may result in issues with the Motor functionality.
• When the motor is not in use, during transport or after operation; make sure to shut off
the gas flow to the engine. Information on shutting off the gas flow to the engine can
be found in the Motor Manual for the Water Trailer. Failure to shut off gas flow when
motor is not in use may result in gas mixing with the oil or may cause damage to the
motor carburetor causing the motor not to function.
• Always follow Manufacturer suggested maintenance requirements and manufacturer
recommendations for any replacement parts.
• Check oil levels before any use to ensure the oil level is at proper operational levels.
See Manufacturers guide for information on oil types and levels.
Lubrication
The wheel bearings should be packed every 6 months or every 6,000 miles (whichever
comes first). Lubrication may be needed more often if the trailer is used in severe
conditions. The wheel hubs should be checked regularly for excess heat. Heat buildup is an
indication that the bearings need greased and may soon fail. It is imperative that the 5th
wheel and pivot pins be lubricated daily in the Hi-Rise trailer front end to prevent premature
wear and failure of the pivoting joints.
Cleaning Your Tank for Potable Water Usage
When cleaning out the tank first drain the system completely. Once the water has been
drained out, refill the tank ¾ full of non-contaminated water. Add 2 gallons of bleach. Drive
tank around briefly to agitate the water around the tank. Then let it soak for a few hours.
Drive around again then dispose of water in compliance with local regulations. Rinse out
tank.
Winterizing Preparation:
The tank and fittings are susceptible to rupture in freezing conditions if water or other fluids
are left in tank or plumbing. To prevent freeze damage, the tank and plumbing should be
drained. Remove all the drain plugs from the system allowing the water to drain out
including the pump drain plug, and then open valves to allow any of the excess water to
drain from the system.
Basic Maintenance:
© 2018 Copyright ABI Attachments, INC
8
Advertisement
Table of Contents
