Table of Contents
Advertisement
Remote Control
PREPARING THE REMOTE CONTROL
To operate the DVD video player, you must first place the batteries in the remote control.
1
Open the cover.
OPERATING WITH THE REMOTE CONTROL
Operating DVD video player with the remote control.
1
1
2
3
4
DIGITAL
AD-703
ON
OFF
1
MIC LEVEL
2
_
+
_
+
1
MIC
2
30˚
30˚
NOTICE (BATTERIES)
FOLLOW INSTRUCTIONS BELOW BECAUSE INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK OR CORRODE
• Do not place the batteries in the wrong direction.
• It is dangerous to charge/heat/open or short-circuit the batteries.
• Do not leave dead batteries or mix old/new batteries in the remote control.
• When not using the remote control for a long duration of time, remove the batteries.
• When difficulties occur, with the remote control, or if the operating range becomes reduced, then replace the batteries.
• If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.
• With normal usage the batteries should last one year.
NOTICE (REMOTE CONTROL)
• The remote control should be aimed directly towards the remote sensor of the DVD video player.
• Avoid dropping the remote control.
• Avoid spilling any liquids and/or extreme heat.
AD-703A
Continued
Insert batteries (AAA size).
Make sure to match the + and - on
the batteries to the marks inside the
battery compartment.
DISC 1
DISC 2
DISC 3
OPEN/CLOSE
TITLE
5
6
7
8
9
0
+10
The remote control must point at the remote sensor, in order for the
PLAY/ENTER
STOP
STEP/
3 DISC
PAUSE
DVD player to function correctly.
AUDIO
SUB-T
ANGLE
MENU
Distance: Maximum of 7 m from the front of the remote sensor.
Angle:
*Please do not place the remote sensor towards any light source such as direct
sunlight or illumination. The DVD video player will malfunction, if you do so.
2
Approximately 30˚ from each direction.
3
Close the cover.
.
A
P
E
X
D
I
G
I
T A
10
L
Advertisement
Table of Contents
