PRODIS MD731 Instruction Manual page 10

MD731/KM1037
Please read the user's manual before using the product and keep it for
future reference. Should you give this device to another person, it
is vital that you also pass on these instructions for use.
ASSEMBLY INSTRUCTIONS
BEFORE ASSEMBLY:
9.
Carefully remove the glass bottle and base from the packaging.
10.
Place them on a soft surface.
11.
Vérifiez que la lampe n'est endommagée. Si le verre est fissuré, ne pas l'utiliser. Check
that the lamp is not damaged. If the glass is cracked, do not use it.
12.
After unpacking the lamp, leave it for about half a day at room temperature before using it.
ASSEMBLY
Bulb to use
1 reflector halogen
bulb R39, height:
65mm (+/- 2mm), E14
socket of 25 W
maximum (supplied),
READ THE
INSTRUCTIONS TO
THE RIGHT!
220-240V 50Hz
BEFORE USING THE LAMP:
- Wait from one to two hours until the liquid in the bottle reaches room temperature.
- Place the lamp on a flat, stable, non-flammable, room-temperature, non-slip surface that can reliably
withstand the weight of the lamp for a long time.
- Do not install it in a drafty room since it could not reach its optimum operating
temperature.
- Do not expose it to direct sunlight that could alter the colors of the liquid.
INSTRUCTION MANUAL
INSTRUCTIONS FOR BULB TYPE
AND BULB INSTALLATION
Only use the type of bulb
mentioned above. The use of
an inappropriate bulb, even of
the same power, may cause a
malfunction, overheating or breakage
of the glass.
- The height of the bulb must be
65mm (+/- 2mm), to allow the lamp to
reach its optimum operating
temperature.
- The cable must be disconnected from
the socket.
- If the lamp was lit before, allow the lamp and
the bulb to cool for at least 30 minutes before
any operation.
PROCÉDURE
1
After Carefully put the
bottle on the base.
screwing,
Make sure the
check that the
lamp is stable
bulb is well
centered and
tightly
screwed.
.
2