Working Condition And Using Method; Working Condition; Using Method - Matsutec HA-102 Operator's Manual

6 Working condition and using method

6.1 Working Condition

According to the requirements of 4.2, connect device and turn on the
power supply, red, yellow, blue, green LED on device flash twice, then
yellow and green LED will keep constant light, and other LED go out. At
this time, the device state at the initialization and GPS positioning.
When GPS positioning is completed, the yellow LED is off, the green LED
is constant light, at this time the device is in normal working condition. If you
find the red LED is in constant light, that indicates the equipment is working
un-properly, you need to check if the power supply voltage, GPS, VHF
antennas connected correctly.

6.2 Using method

6.2.1 Normal working
The transponder needs to be connected with display
terminal, in normal situation, users only need to make
various operations and settings to the display terminal,
no need to operate the transponder.
6.2.2 Emergency Call
When meet emergency situation, press down the red
"Safety Alarm" button on the front up panel, Safety signal
will be sent out.
11