Central settings / System time menu
3.6
Faults
3.6.1
Fault alarms
Fonterra Smart Control
Fig. 73: System time
Indication of the current system time in "dd.mm.yy - hh.mm" format.
If the end device shows an incorrect time, check the time settings and
the time zone.
The base stations are equipped with battery buffers to pro‐
tect them from data loss in case of power failure.
Base stations, room thermostats, and actuator modules flash red to
indicate that a fault is pending. To identify the cause of the fault, count
the number of flash signals in one interval and consult the table below
for the potential cause.
For plain text indication of the faults in the operating software, see
Ä „Central settings / Fault menu" on page 104.
LED flashing red
One fault at a time can be indicated only: After remedying
the fault, check whether other fault alarms are pending.
Handling
106 from 115