Table of Contents
Advertisement
Chapter 3 - Installation
7. Install the two front retainer brackets.
a. Loosen the vinyl cap covered stop pegs and slide them to the outer end of their adjustment
b. Engage and tighten the two captivated panel fasteners in each front retainer bracket into the
c. Adjust the stop peg on each front retainer bracket so it is in contact with the server front bezel,
3.4.4
Connecting the cables
To connect the cables
slots.
threaded standoffs protruding from the side brackets.
as shown above. Tighten the stop peg hex standoffs.
- 37 -
Advertisement
Table of Contents
