Haverland IGLU Instruction Manual page 20

• Make sure the plug is plugged firmly and completely into the outlet, otherwise it can result in the risk of electric
shock or fire.
• Do not plug other appliances into the same outlet, it can result in the risk of electric shock.
• Do not disassemble or modify the appliance or the power cord, it can result in the risk of electric shock or fire. All
other services should be referred to a qualified technician.
• Do not place the power cord or appliance near a heater, radiator, or other heat source. It can result in the risk of
electric shock or fire.
• This unit is equipped with a cord that has a earthed wire connected to an earthed pin or grounding tab. The plug
must be plugged into a socket that is properly installed and earthed. Do not under any circumstances cut or remove
the earthed pin or grounding tab from this plug.
• The unit should be used or store in such a way that it is protected from moisture e.g. condensation, splashed water,
etc. Unplug unit immediately if this occurs.
• Always transport your appliance in a vertical position and place on a stable, level surface during use. If the unit is
transported laying on its side it should be stood up and left unplugged for 6 hours.
• Always use the switch on the control panel or remote control to turn the unit off, and do not start or stop operation
by plugging in or unplugging the power cord. It can result in the risk of electric shock.
• Do not touch the buttons on the control panel with your wet and damp fingers.
• Do not use hazardous chemicals to clean or come into contact with the unit. To prevent damage to the surface
finish, use only a soft cloth to clean the appliance. Do not use wax, thinner, or a strong detergent. Do not use the
unit in the presence of inflammable substance or vapour such as alcohol, insecticides, gasoline, etc.
• Young children should be supervised to ensure that they do not play with, operate or climb on the appliance.
• If the appliance is making unusual sounds or is emitting smoke or an unusual odor, unplug it immediately.
• Do not clean the unit with water. Water can enter the unit and damage the insulation, creating a shock hazard. If
water enters the unit, unplug it immediately and contact Customer Service.
• Utilize two or more people to lift and install the unit.
• Be sure all accessories are removed from the packing before use.
• To avoid possible cuts, avoid contacting the metal parts of the appliance when removing or re-installing the filter. It
can result in the risk of personal injury.
• Do not block the air inlet or outlet of the appliance. Reduced air flow will result in poor performance and could
damage the unit.
• Always grasp the plug when plugging in or unplugging the appliance. Never unplug by pulling on the cord. It can
result in the risk of electrical shock and damage.
• Install the appliance on a sturdy, level floor capable of supporting up to 110lbs(50kg). Installation on a weak or
unleveled floor can result in the risk of property damage and personal injury.
• Close all doors and windows to the room for most efficient operation.
IMPORTANT - GROUNDING METHOD
This product is factory equipped with a power supply cord that has a three-pronged grounded plug. It must be plugged
into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes
and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the
customer to exchange the existing receptacle in accordance with the National Electrical Code and applicable local
codes and ordinances. The third ground prong should not, under any circumstances, be cut or removed. Never use the
cord, the plug or the appliance when they show any sign of damage. Do not use your appliance with an extension cord
unless it has been checked and tested by a qualified electrical supplier. Improper connection of the grounding plug can
result in risk of fire, electric shock and/or injury to persons associated with the appliance. Check with a qualified service
representative if in doubt that the appliance is properly grounded.
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
• The mains power supply corresponds to the value indicated on the rating plate on
• the back of the appliance.
- 2 -