Panasonic TY-ST85P12 Installation Instructions Manual page 20

Assembly
2) Align the hole position of grounding plate
with the grounding plate screw
during Step 1, then put on grounding plate
3) Push the grounding plate
2 toward the plasma display side, and align the
hole positions with the display mounting fixture
.
※ Make contact between the gasket on the
front of the grounding plate and the plasma
display.
4) Insert the grounding plate screws
numeric order shown in the illustration.
(5 is the loosely inserted screw from Step 1.
Insert so that the washer does not get wedged
in.)
Assemble the right side the same way.
•
The screws should be securely tightened to
the torque given below.
(1.2~1.5 N•m)
5) Using 4 grounding plate screws
grounding plate (small)
fixture and supports
Assemble the right side the same way.
•
The screws should be securely tightened to
the torque given below.
(1.2~1.5 N•m)
4. Mounting the light shield
1. Remove the 3 back cover mounting screws on the
plasma display's rear panel.
20
mounted
.
mounted in Step
in the
, mount
to display mounting
.
Gasket
5
4
3
2
1
Gasket
Grounding plates
(small)
Grounding plate screws
Back cover mounting screws
5
4
3
Rear
2
1
Rear