Panasonic TY-ST85P12 Installation Instructions Manual page 19

2. Join the stand hooks to the 4 notches
on the display mounting fixture and
let them drop in until they stop.
3. Starting with the upper left side of the left and
right display mounting fixtures
screws for securing unit
•
The screws should be securely tightened to the
torque given below.
(1.2~1.5 N•m)
Note
•
Do not over-tighten the screws for securing unit
as this could cause the fixtures to deform.
4. Remove the suspension device.
Remove the eye bolt and insert the eye bolt cap
(provided with the plasma display).
※ Carefully store the removed eye bolt.
5. Installing the grounding plate
Notes
•
The stamped marks (L and R) on the grounding plates
are as seen from the rear of the display.
•
Attach the grounding plates the same way for both
supports (left and right).
1) Loosely insert the grounding plate screws
each on the left and on the right) to the holes on
the upper end of display mounting fixtures
Stand hooks
, attach the 2
.
,
(2
.
Screw for securing unit
Front
Grounding plate screws
Front
Display mounting fixtures
Notches
Rear
Rear
19