Default Mode (Reset) - AMX RDA-ENC2 Instruction Manual

1 2 3
FIG. 21 9-pin dry closure connector (standard configuration)
Each contact closure connection (1 through 8) is pre-programmed with a default preset. The
following table shows the default presets for each contact closure.
Dry closure default presets
Contact closure Default function
1
2
3
4
5
6
7
8
*All other channels are undefined.

Default Mode (Reset)

Default mode is resetting the AMX Lighting module values to zero and the module then begins to
function on the values you previously programmed into the module. If you experience problems
after installing a lighting system, you may need to reset the controller module to default mode.
Then, you should be able to determine if there is a problem with the connections, programming,
and/or dimming.
To reset a AMX Lighting controller to default mode:
1. Power off the AMX Lighting enclosure at the circuit breaker panel.
2. Disconnect all AXlink and PROlink cables from the controller module.
3. Connect a jumper to the dry contact closures 1 through 8 and to ground as shown in FIG. 22.
1 2 3 4
FIG. 22 9-pin dry closure connector set to default mode
Radia Lighting Control System
C
O
M
4 5 6 7 8
9-pin Dry Closure Connector
Channel 1 at 100% in 1 second*
Channel 2 at 100% in 1 second*
Channel 3 at 100% in 1 second*
Channel 4 at 100% in 1 second*
Channel 5 at 100% in 1 second*
Channel 6 at 100% in 1 second*
Pack on (channels 1-6)*
Pack off (channels 1-6)*
C
O
M
5 6 7 8
9-pin Dry Closure Connector
Installation
17