Atwood Round-O-Matic R-900C Series Operation And Safety Manual page 10

A.M. MFG. CO.
DIV. OF ATWOOD CORP.
©2007
GUIDE TO GENERAL MAINTENANCE
SHOULD IT BECOME NECESSARY TO
REPLACE ANY OF THE TABLE SUPPORT
BEARINGS, (PART NO. R214TA - R216TA),
CARE SHOULD BE TAKEN NOT TO LOOSEN
THE NUTS SECURING THE TABLE SUPPORT
POSTS, AS TABLE DRUM ALIGNMENT WILL BE
LOST.
SIMPLY PULL ASIDE THE CLIP HOLDING THE
BEARINGS DOWN, AND LIFT THE BEARINGS
STRAIGHT UP.
NOTE:
THESE INSTRUCTIONS WILL HELP YOU SERVICE THE UNIT. INSTRUCTIONS ARE FOR A PERSON WITH SOME
MECHANICAL ABILITY AND TRAINING. NO ATTEMPT HAS BEEN MADE TO DESCRIBE ALL BASIC STEPS, FOR EXAMPLE, HOW TO
LOOSEN OR TIGHTEN FASTENERS. ALSO, BASIC PROCEDURES LIKE HOW TO CYCLE SYSTEMS AND CHECK OPERATION OF THE
EQUIPMENT ARE NOT DESCRIBED SINCE THEY ARE KNOWN TO ANYONE WHO DOES MECHANICAL AND SERVICE WORK. DO
NOT ATTEMPT TO PERFORM WORK BEYOND YOUR ABILITY OR AT WHICH YOU HAVE NO EXPERIENCE. IF YOU NEED
ASSISTANCE, CALL AN AUTHORIZED SERVICE CENTER OR CONTACT A.M. MANUFACTURING AT (800) 342-6744...
R900_7
DANGER:
ALWAYS DISCONNECT ELECTRICAL POWER SOURCE AND
TURN MACHINE SWITCH TO THE OFF POSITION BEFORE
CLEANING, MAINTAINING OR REPAIRING THIS MACHINE...
LOCATE THE RING GEAR (PART NO. R213TA)
(TABLE MODEL ONLY). ADD A SMALL
AMOUNT OF GREASE ONTO THE RING
GEAR.
7
MODEL:
R-900
12/07