ETC Echo Expansion Bridge Installation Manual page 8

ETC Installation Guide
Expansion Bridge
Configuration
Configuration of the Expansion Bridge is accomplished using the
EchoAccess App or Unison Paradigm LightDesigner software. Reference
the integrated help system for the configuration tool for details about
configurable device parameters and actions available.
Remove the Bridge from DIN rail
If for any reason you need to remove the Expansion Bridge from the DIN
rail, follow these instructions.
1.
2.
3.
4.
Expansion Bridge
Power off Echo station power supplies on all connected Echo
segments.
If 24 VDC is still present, power off the auxiliary power source.
Disconnect all wiring and cap off as necessary.
Insert a flat blade screwdriver into the clip on top of the bridge,
slide it straight up, then pivot the top of the bridge off of the DIN
rail.
Page 8 of 8 ETC